[. . . ] Due to our continuing program of research and development, the specifications herein are subject to change without notice. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. [. . . ] Keep the tool in position and prevent it from slipping away from the hole. Do not apply more pressure when the hole becomes clogged with chips or particles. CAUTION: When the bit begins to break through concrete or if the bit strikes reinforcing rods embedded in concrete, the tool may react dangerously. Maintain good balance and safe footing while holding the tool firmly with both hands to prevent dangerous reaction. The side grip swings around to either side, allowing easy handling of the tool in any position. Loosen the side grip by turning it counterclockwise, swing it to the desired position and then tighten it by turning clockwise. 4) Rotation only: For drilling in wood or metal, press the push rod in the direction. 5) CAUTION: To avoid rapid wear on the mode change mechanism, be sure to press the push rod as far as it will go. 7) CAUTION: To avoid rapid wear on the mode change mechanism, be sure that the change lever is always positively located in one of the two action mode positions. Install the bit, then attach the dust collector on the end by turning and applying pressure. CAUTION: Empty the dust collector of its contents after drilling every 2 or 3 holes. CAUTION: When the drill chuck is installed on this tool, do not use ``rotation with hammering'' action. Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. Do not tape, tie or otherwise secure the trigger in the ``ON'' position. [. . . ] Använd borrchucken och chuckadaptern, som finns som extra tillbehör, för borrning upp till 10 mm i metall och upp till 15 mm i trä. : series production) manufactured by Makita Corporation in Japan is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. The typical A-weighted noise levels are sound pressure level: 90 dB (A) sound power level: 103 dB (A) ­ Wear ear protection. [. . . ]